HP ProLiant BL10e G2 Server Blade - Manual (Page 181)

Performing Advanced Functions
The POWERON BAY and REBOOT BAY commands have been extended to allow an
argument which sets server blade boot order for that boot only. These settings are the
same as the
SET BAY BOOT ONCE command.
To determine if any boot order changes are pending for a specific blade, use the SHOW
BAY INFO command. The “Pending Boot Order:” status line will show any pending
changes to the boot order, either one-time or permanent.
Powering Off the Enclosure
CAUTION: Powering off the enclosure removes all power from the server blades
and ends all open sessions. After powering off the enclosure, you can only power on
the enclosure if you have physical access to the enclosure.
To power off the enclosure using the Web-based user interface:
1. Click the Enclosure tab.
2. Click Virtual Buttons in the left panel.
Figure 7-1: Accessing Virtual Buttons
7-8 HP ProLiant BL e-Class Integrated Administrator User Guide
HP CONFIDENTIAL
Writer: Hilary Stead File Name: h-ch7 Performing Advanced Functions.doc
Codename: Halo Part Number: 249070-005 Last Saved On: 3/1/04 10:54 AM