HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 109)

Command line 109
Item Description
Parameter
ModuleID (required) Specifies the interconnect module whose network interface is being reset. The
format is <EnclosureId>:<BayNumber>.
The module network configuration cannot be reset if the module ports are being
sampled or polled by any of the receivers.
Examples
->reset sflow-module enc0:1
Resets the module network interface configuration on enc0:1
->reset sflow-module *
Resets the module network interface configuration on all associated sflow
modules
Item Description
set sflow-module Modify an sflow module.
Syntax
set sflow-module <ModuleID>
DHCP=<Enabled/Disabled>[IpAddress=<IPAddress>
SubnetMask=<mask>[Gateway=<Gateway>]]
Parameter
ModuleID (required) Specifies the interconnect module whose network interface is being configured.
The format is <EnclosureId>:<BayNumber>.
Properties
DHCP (required) Specifies if the network interface created for sflow is being configured through
DHCP or by a user providing the static IP settings.
IpAddress (optional) Specifies a valid IP address to use for the network interface created for sflow
network configuration. This property is required if DHCP is disabled.
SubnetMask (optional) Specifies a valid subnet mask for the network interface created for sflow network
configuration. This property is required if DHCP is disabled.
Gateway (optional) Specifies a valid gateway address for the network interface created for sflow.
This property is specified if DHCP is disabled.
When DHCP is disabled, the user should provide a unique IP address for each
module.
Example
->set sflow-module enc0:1 DHCP=Enabled
Enables DHCP on the enc0:1 module
->set sflow-module enc0:1 DHCP=Disabled
IpAddress=10.10.1.11 SubnetMask=255.255.252.0
Gateway=10.10.10.1
Configures the static IP settings on enc0:1
Item Description
show sflow-module Display the sflow module.
Syntax
show sflow-module [<ModuleID|*>
Parameter
ModuleID (optional) Specifies the interconnect module whose network interface is being displayed.
The format is <EnclosureId>:<BayNumber>.
Examples
->show sflow-module
Displays all sflow modules