HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 83)

Command line 83
Item Description
->set network Network1 Color=red
Sets the network color to red
Item Description
show network Display all Ethernet networks in the domain.
Configured values for ConnectionMode and VLanTunnel display for UNSHARED
networks only.
Configured values for NativeVLAN, UplinkSet, and VLanID display for SHARED
networks only.
Syntax
show network [<NetworkName>|*]
Parameter
NetworkName
(optional)
The name of an existing network (Ethernet or FCoE) in the VC domain. Use "*" to
display a detailed view of all the networks. If not specified, a summary view of the
networks appears.
Examples
->show network
Displays a summary of all networks
->show network *
Displays detailed information for all networks
->show network MyNetwork
Displays detailed information for a specific network
port-monitor
Manage port monitor configuration.
Supported actions: help, add, remove, set, show
Item Description
add port monitor Add a new network analyzer port and other ports to be monitored.
Syntax
add port-monitor [AnalyzerPort=<PortID>]
[Speed=<Auto|10Mb|100Mb|1Gb|10Gb|40Gb|Disabled>]
[Duplex=<Auto|Half|Full>] [MonitorPort=<PortID>]
[Direction=<ToServer|FromServer|Both>]
Properties
AnalyzerPort
(optional)
The uplink port that is used for monitoring network traffic. Only one port can be
configured as the analyzer port. After a port is allocated to port monitoring, it is not
available for use in VC networks and shared uplink sets. The format of the network
analyzer port is <EnclosureID>:<InterconnectBay>:<PortNumber>. For
QSFP+ ports, the <PortNumber> format is Q<x>.<y>.
If the EnclosureID is not specified, the default enclosure is the local enclosure where
the domain resides.
Speed (optional) The port speed for the network analyzer port. Valid values include "Auto",
"10Mb", "100Mb", "1Gb", "10Gb", "40Gb", and "Disabled". The default value
is "Auto".
If there is no connector present on the analyzer port, only "Auto" and "Disabled"
can be configured as the port speed. Speed restrictions apply.
Duplex (optional) The duplex mode of the network analyzer port. Valid values include "Auto", "Half",
and "Full". The default value is "Auto".