HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 7)

Introduction 7
Changes from VC 4.10 to VC 4.20
Command Changes Virtual Connect 4.10 Virtual Connect 4.20
set cli
help cli
The new managed
element modifies
command execution
behavior in script
mode and
auto-deployment.
Not supported Both of these commands
are supported.
set sflow
show sflow
help sflow
The new managed
element configures
the existing VC
Ethernet network used
to send datagrams to
the receiver.
Not supported All of these commands are
supported.
help sflow-module
reset sflow-module
set sflow-module
show sflow-module
The new managed
element configures
the network settings
for the network
interface created for
sflow.
Not supported All of these commands are
supported.
add sflow-ports
help sflow-ports
remove sflow-ports
set sflow-ports
show sflow-ports
The new managed
element configures
the ports to be
sampled or polled for
a receiver.
Not supported All of these commands are
supported.
add sflow-receiver
remove sflow-receiver
help sflow-receiver
set sflow-receiver
show sflow-receiver
The new managed
element configures
the receivers.
Not supported All of these commands are
supported.
show lldp
reset statistics
show statistics
add uplinkport
remove uplinkport
set uplinkport
show uplinkport
Modified the
commands to include
QSFP+ uplink ports
show lldp <PortID>
where the format of the
<PortID> is
<EnclosureID>:<Int
erconnectBay>:<Por
tLabel>
show lldp <PortID>
where the format of the
<PortID> is
<EnclosureID>:<Int
erconnectBay>:<Por
tLabel>.
For QSFP+ ports, the
<PortLabel> format is
Q<x>.<y>.