HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 33)

Command line 33
Item Description
pool. Deleting the domain is the only way to return "User-Defined"
addresses to the pool.
To use the "Pool-Specified" option, the domain MAC pool must be defined
as VC-defined or user-defined and the listed addresses must be available
in the current pool.
EthernetMAC (required if
AddressType is User-Defined
or Pool-Specified)
The user-defined Ethernet MAC address to use for the connection. This
property is required if the AddressType specified is "User-Defined" or
"Pool-Specified".
iScsiMAC (required if
AddressType is User-Defined
or Pool-Specified)
The user-defined iSCSI MAC address to use for the connection. This
property is required if the AddressType specified is "User-Defined" or
"Pool-Specified".
SpeedType (optional) The requested operational speed for the server port. Valid values include
"Auto", "Preferred", "Custom", and "Disabled". The default value is
"Preferred".
If the speed type is "Auto", the maximum port speed is determined by the
maximum configured speed for the network.
If the speed type is "Preferred", the speed of the network is the same as the
preferred speed of the network to which the connection is associated. If no
preferred speed is configured for a network, it defaults to "Auto".
If the speed type is "Custom", you can configure a speed from 100Mb to
MAX configured speed for the network in 100Mb increments.
If the speed type is "Disabled", bandwidth is not allocated and the server
port status is "Administratively Disabled".
Speed (required if the
SpeedType is Custom)
The user-defined speed for the server port. Valid values include 100Mb to
MAX configured speed for the network in 100Mb increments.
Examples
->add enet-connection MyNewProfile
Network=SomeNetwork
Adds a new Ethernet network connection to a profile
->add enet-connection MyNewProfile
Network=SomeNetwork2 PXE=enabled
Adds a new Ethernet network connection and enables PXE
->add enet-connection MyNewProfile
Adds a new Ethernet network connection and leaves the network
unassigned
->add enet-connection MyNewProfile
AddressType=Factory-Default
Adds a new Ethernet network connection and uses factory default
addresses
->add enet-connection MyNewProfile
AddressType=User-Defined
EthernetMAC=00-17-A4-77-00-00
iScsiMAC=00-17-A4-77-00-01
Adds a new Ethernet network connection and provides user-defined MAC
addresses
->add enet-connection MyNewProfile
AddressType=Pool-Specified
EthernetMAC=00-17-A4-77-00-00
iScsiMAC=00-17-A4-77-00-01
Adds a new Ethernet network connection and specifies an address from
the VC-defined or user-defined pool
->add enet-connection MyProfile Network=MyNetwork
SpeedType=Preferred
Adds a new Ethernet network connection and sets the speed to