HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 66)

Command line 66
Item Description
Examples
->set log-target 1 Severity=Error Transport=TCP
Security=STunnel
Modifies log-target index number 1
->set log-target 1 Destination=192.168.3.1
Modifies log-target at index 1 to use a new IP address
->set log-target 1
Destination=2001:0db8:85a3:0000:0000:8a2e:0370:7334
Modifies log-target at index 1 to use a new IPv6 address
Item Description
show log-target Display the remote log destination settings.
Syntax
show log-target [<ID|*>]
Parameter
ID (optional) The index of the remote log destination to view. Use "*" to display detailed
information for all remote log destinations.
Example
->show log-target
Displays all log destination settings
Item Description
test log-target Send a test message to all enabled remote log destinations.
Syntax
test log-target
Example
->test log-target
Sends a test message all log-targets
loop-protect
The loop-protect command is deprecated in 4.00. HP recommends using the port-protect command. For
information about port-protect settings, see "port-protect (on page 85 )."
Manage loop protection settings.
Supported actions: help, reset, set, show
Item Description
reset loop-protect Reset and restart loop detection for all server ports in a “loop-detected” error
condition.
Syntax
reset loop-protect
Example
->reset loop-protect
Resets and restarts loop detection for all server ports in a “loop-detected” error
condition
Item Description
set loop-protect Configure the loop protection settings.
Syntax
set loop-protect [-quiet] Enabled=<true|false>