HP Vectra VL 6xxx series 8 - Manual (Page 56)

Appendix A The Error Codes
0001h – 00CCh: System Error Codes
44 English
0009h Cannot enable the A20 line. Keyboard controller error.
Check connections to the keyboard controller.
If error persists, install new system board.
0010h 32-bit register read or write error. Processor error.
Check that the processor is correctly installed.
If the error persists, install new processor.
0011h PUSHA(D) or POPA(D) execution error. Processor error.
Check that the processor is correctly installed.
If the error persists, install new processor.
0012h Cannot access data through the FS or GS
registers. Processor error.
Check that the processor is correctly installed.
If the error persists, install new processor.
0013h BSF or BSR execution error. Processor error.
Check that the processor is correctly installed.
If the error persists, install new processor.
0014h FLAG Register Set or Reset error. Processor error.
Check that the processor is correctly installed.
If the error persists, install new processor.
0015h Protected mode instruction execution
error. Processor error.
Check that the processor is correctly installed.
If the error persists, install new processor.
0016h 32-bit multiplication error. Processor error.
Check that the processor is correctly installed.
If the error persists, install new processor.
001Eh The detected processor Speed is not the
same as specified. Processor clock error.
Check that correct clock speed is selected by system
board switches.
Code Explanation Details/Parts to Check
guard.bk : g-e-ref1.fb4 Page 44 Wednesday, June 30, 1999 3:06 PM