HP NonStop G-Series - Manual (Page 107)

SCSI Controller
A number (1 or 2) that identifies the backup SCSI controller that manages the
disk.
Example: SCSI Controller (1.1.50.2)
Access State
The accessibility of the backup path.
Values: Inactive, Active
Configured
Controller Location
The location of the backup disk path SCSI controller.
Example: IOMF2.SAC-2.GRP-1.MOD-1.SLOT-55
Primary Path
SCSI ID An identification number assigned to the device when configured.
SCSI Controller
A number (1 or 2) that identifies the primary SCSI controller that manages
the disk.
Example: SCSI Controller (1.1.50.2)
Access State
The accessibility of the primary path.
Values: Inactive, Active
Configured
Controller Location
The location of the primary disk path SCSI controller.
Example: IOMF2.SAC-2.GRP-1.MOD-1.SLOT-50
Firmware
Version The version of the firmware running on the disk.
Actions
Abort Backup Path
Terminates operation of the backup path to the disk. When the Abort action finishes, the path is in a
Hard Down state. You must use the Reset Backup Path action before you can start the path again.
Abort Disk
Terminates operation of the all paths for the disk. When the Abort action finishes, the paths are in a
Hard Down state. You must use the Reset Disk action before you can start the paths again.
Abort Primary Path
Terminates operation of the primary path to the disk. When the Abort action finishes, the path is in
the Stopped state.
BLINK LED Off
Stops the blinking of the fault LED initiated by the Blink LED On action.