HP Compaq Integrated Smart Array Controller - Manual (Page 47)

Installing the Operating System Drivers 5-7
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq Integrated Smart Array Controller User Guide Comments:
Part Number: 153236-001 File Name: f-ch5 Installing the Operating System Drivers.doc Last Saved On: 8/26/99 8:12 PM
Installation Procedure
The following steps outline the procedure to install the Integrated Smart Array
Controller driver for Novell NetWare on your server.
1. If the server is not running, start the server from the boot hard drive.
2. Insert the Novell SSD diskette three created from SmartStart into the
diskette drive.
3. Copy CPQARRAY.HAM, CPQARRAY.DDI, and CPQSHD.CDM from
the Novell SSD diskette to C:\NWSERVER.
NOTE: The boot hard drive containing the primary DOS partition is usually the C drive. If
your primary DOS partition is located on a different drive, type the letter for that drive in
place of the letter C in the example above.
4. Edit the STARTUP.NCF file so that the driver is loaded automatically at
system startup.
5. Reboot the server.
6. Refer to your NetWare installation documentation for information about
installing and mounting volumes associated with your new disk
subsystem.
Compaq Online Array Configuration Utility
for NetWare (CPQONLIN)
The Compaq Online Array Configuration Utility for NetWare,
CPQONLIN.NLM, version 2.30A or later, is an NLM that allows you to
configure your drive arrays without shutting down your NetWare server. The
CPQONLIN.NLM is located on diskette 4 in the \ONLINE directory of the
Novell SSD diskettes you created from the SmartStart CD. Load the NLM and
follow the instructions on the screen to use this online utility to configure your
drive arrays.
The Compaq Online Array Configuration for NetWare utility cannot be used
until after the driver, CPQARRAY.HAM, is installed, either with the latest
version of SmartStart or manually as described in this chapter.
Chapter 6 provides detailed instructions about running the Compaq Online
Array Configuration Utility.