HP Compaq Integrated Smart Array Controller - Manual (Page 52)

5-12 Compaq Integrated Smart Array Controller User Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq Integrated Smart Array Controller User Guide Comments:
Part Number: 153236-001 File Name: f-ch5 Installing the Operating System Drivers.doc Last Saved On: 8/26/99 8:12 PM
NOTE: For the command line, the letter A denotes the diskette drive. The letter for the
diskette drive on your server may be different.
4. Select Custom Setup.
5. Select the Integrated Smart Array Controller as your device.
6. Click Update.
7. The setup program updates the driver on your system from the Compaq
SSD diskettes.
8. Select Close to exit the setup program or select other components to
install, update, or remove drivers.
9. Remove the Compaq SSD diskette.
10. Shut down Windows NT and restart the system to load the driver.
Installing the Integrated Smart Array Controller
Driver After Windows Installation
Device drivers are located on the Compaq SSD for Windows NT diskettes and
are installed from the Windows Setup utility. Setup identifies hardware
components that are physically installed on the system and recommends
device drivers that you should install or update.
Existing Windows NT 4.0 Installation
Install the Integrated Smart Array Controller through the Windows Setup
utility:
1. Start Windows NT on the system and logon to an account with
administrative privileges.
2. Insert the Compaq SSD for Windows NT diskette 1 into the diskette
drive.
3. From the Program Manager, select File, then Run.
4. Type in the file name:
A:\SETUP
NOTE: For the command line, A: denotes letter for a diskette drive. The letter for the
diskette drive on your server may be different.
5. Select Custom.