HP XP Continuous Access Software - Manual (Page 161)

6. Select Add.
The JNL Volumes list shows the volumes that you want to register. The Operation column of
the list shows Add.
7. Click Set to close the Edit JNL Volumes window.
8. See the Preview list to check the settings that you have made.
•
To add volumes to register, select and right-click a volume in the Preview list, and then
select Modify. A window opens and allows you to add volumes.
•
To cancel registering a volume, select and right-click the volume, and then select Cancel.
•
If necessary, you can repeat steps 3 to 8 to add volumes to other journal groups.
9. Click Apply to register journal volumes.
After volumes are registered, the journal groups are shown below Registered in the tree. If an
error occurs, the error code appears in the right column of the Preview list. To view detailed
information about the error, right-click the error code and select Error Detail.
Figure 72 Edit JNL Volumes Window
The Edit JNL Volumes window shows the following:
•
JNL Volumes: Information about journal volumes.
Parity Group: The parity group where a journal volume belongs. A parity group name
beginning with E indicates the journal volume is an external volume. ◦
◦ LDKC:CU:LDEV: The LDKC number, the CU number, and the LDEV number of a journal
volume. A volume ending with # indicates the volume is an external volume.
◦ Capacity: The capacity of a journal volume in gigabytes.
◦ Emulation The emulation type of a journal volume.
Registering Journal Volumes in a Journal Group 161