HP XP Continuous Access Software User Manual
Page 233
Table 45 Error Codes and Error Contents When Operating RAID Manager (continued)
Error Contents
Error Code
(SSB2)
Error Code
(SSB1)
E882
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the emulation type of the
specified master journal group or the restore journal group was invalid.
The specified mirror ID number or the CTG number differs from the
registered mirror ID number or the CTG number.
E883
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified master journal
group was already used for a pair with another restore journal group.
E888
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified journal group
was already used in another XP Continuous Access Journal’s mirror ID.
E889
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified volume was
already registered on the journal group.
E890
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the number of pairs that
are registered in the specified master journal group or restore journal
group already reached the maximum number.
E891
When creating a pair using journal group in the configuration where
three XP Continuous Access Journal sites were combined, a request of
pair creation of the third mirror was received in the same journal group,
so the command was rejected.
E894
A request of Paircreate was received. However, the command was rejected
because of the one of following reasons.
•
The specified primary journal group and the secondary jorunal group
do not permit the configuration combining three XP Continuous Access
Journal sites.
•
The specified secondary journal group is already used as a secondary
journal group of another mirror.
•
The paired journal group of the specified mirror is already used by
another mirror.
E897
When creating a pair using journal group that does not permit the
configuration combining three XP Continuous Access Journal sites, because
a paircreate request of the second mirror was received in the same journal
group, the command was rejected.
E898
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the path between the
storage devices for the both-way was not defined. Check whether the
bidirectional normal path was defined or not.
E89A
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified master journal
group or the restore journal group remembered the state of connection
with another storage system in the past. Specify another journal group,
or delete the journal group once, then retry the registration again.
E89B
The specified journal group number is unregistered.
E8A6
Journal volume is unregistered on the specified journal group.
E8A7
A request of XP Continuous Access Journal suspend pair was received.
However, the command was rejected because the specified volume was
not for an XP Continuous Access Journal pair or was a volume of another
journal group.
E8A8
Troubleshooting When Using RAID Manager 233