HP XP Continuous Access Software - Manual (Page 240)

Table 45 Error Codes and Error Contents When Operating RAID Manager (continued)
Error Contents Error Code
(SSB2)
Error Code
(SSB1)
EB88 The XP Continuous Access Journal pair was not created because the
specified S-VOL was in one of the following statuses:
•
The specified S-VOL was being used as the XP Business Copy S-VOL.
• The specified S-VOL was Not Ready, which means that the hard disk
drive cannot be used.
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the emulation types of the
specified P-VOL and S-VOL were not the same. EB89
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the emulation types of the
specified master journal group and the restore journal group were not the
same. EB8A
The XP Continuous Access Journal pair cannot be created because the
LUSE configuration of the P-VOL was different from the LUSE configuration
of the S-VOL. EB8E
A request of XP Continuous Access Journal pair status transition was
received. However, the command was rejected because the specified
pair could not transit the status. EB94
A request of XP Continuous Access Journal pair status transition was
received. However, the command was rejected because the specified
S-VOL was not mounted on the secondary storage system. EBA0
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the volume specified for
the secondary volume was in one of the following statuses:
• Increasing the capacity by XP Thin Provisioning.
•
Releasing the page of XP Thin Provisioning.
• Being initialized by XP Business Copy.
EBA7
The XP Continuous Access Journal pair cannot be created because the
license capacity of Data Retention Utility in the secondary storage system
exceeds the setting value. Check the license capacity setting of Data
Retention Utility in the secondary storage system. EBAF
The XP Continuous Access Journal pair for delta resync operation cannot
be created because the specified XP Continuous Access Journal S-VOL
was used by either one of the following two programs:
•
XP Business Copy
•
XP FlashCopy
EBC6
A request for XP Continuous Access Journal Pairresync (journal resync
mode) was received. However, the command was rejected because the
journal restore operation is in progress in the XP Continuous Access Journal
pair having another mirror ID. If the XP Continuous Access Journal pair
having another mirror ID is in the Suspending status, reissue the request
after the pair status changes to the Suspend status. If the XP Continuous
Access Journal pair having another mirror ID is in the PAIR status, reissue
the request after a short delay. EBCA
The XP Continuous Access Journal pair cannot be resynchronized
(DELTAJNL parameter specifying), because the not-updated differential
information exists in the specified S-VOL. EBCE
EBCF
240 Troubleshooting