Supervisor message, Checking the settings, Supervisor message checking the settings – Vaisala WXT510 User Manual
Page 110
Advertising
User’s Guide ______________________________________________________________________
108 _________________________________________________________________ M210470EN-D
Supervisor Message
Checking the Settings
With this command you can check the current supervisor settings.
Command format in ASCII and NMEA 0183: aSU<cr><lf>
Command format in SDI-12: aXSU!
The response in ASCII and NMEA 0183:
aSU,R=[R],I=[I],S=[S],H=[Y]<cr><lf>
The response in SDI-12:
aXSU,R=[R],I=[I],S=[S],H=[Y]<cr><lf>
where
a
=
Device address
SU
=
Supervisor settings command in ASCII and NMEA
0183
XSU
=
Supervisor settings command in SDI-12
<cr><lf>
=
Command terminator in ASCII and NMEA 0183
!
=
Command terminator in SDI-12
Advertising