Vaisala WXT510 - Manual (Page 57)

Chapter 7 __________________________________________________ Getting the Data Messages
VAISALA _______________________________________________________________________ 55
Example (ASCII):
0XZRU<cr><lf>
0TX,Rain reset<cr><lf>
Example (SDI-12):
0XZRU!0<cr><lf> (= device address)
Example (NMEA 0183):
0XZRU<cr><lf>
$WITXT,01,01,10,Rain reset*26<cr><lf>
Precipitation Intensity Reset
(aXZRI)
This command is used to reset the rain and hail intensity parameters Ri,
Rp, Hi and Hp.
Command format in ASCII and NMEA 0183: aXZRI<cr><lf>
Command format in SDI-12: aXZRI!
Example (ASCII):
0XZRI<cr><lf>
where
a
= Device address
XZRI = Precipitation intensity reset command
<cr><lf> = Command terminator in ASCII and NMEA 0183
! = Command terminator in SDI-12
NOTE The precipitation counter and precipitation intensity parameters are
reset also when the supply voltage is disconnected, the command aXZ
is issued, precipitation counter reset mode is changed or when the
precipitation/surface hits units are changed.