Supervisor data message (ar5), Combined data message (ar) – Vaisala WXT510 User Manual
Page 64
User’s Guide ______________________________________________________________________
62 __________________________________________________________________ M210470EN-D
Supervisor Data Message (aR5)
With this command you can request a supervisor data message
containing self-check parameters of the heating system and power
supply voltage.
Command format: aR5<cr><lf>
Example of the response (the parameter set is configurable):
0R5,Th=25.9C,Vh=12.0N,Vs=15.2V,Vr=3.475V<cr><lf>
To change the parameters and units in the response message and to
make other settings, see section
Supervisor Message on page 108
.
Combined Data Message (aR)
With this command you can request all individual messages aR1, aR2,
aR3 and aR5 with just one command.
Command format: aR<cr><lf>
where
a
=
Device address
R5
=
Supervisor message query command
<cr><lf>
=
Command terminator
where
a
=
Device address
R5
=
Supervisor message query command
Th
=
Heating temperature (C = °C)
Vh
=
Heating voltage (N = heating is off)
Vs
=
Supply voltage (V = V)
Vr
=
3.5 V reference voltage (V = V)
<cr><lf>
=
Response terminator