Vaisala WXT510 - Manual (Page 122)

User’s Guide ______________________________________________________________________
120 _________________________________________________________________ M210470EN-D
0xUabc!0TX,Use chksum CCb<cr><lf> (wrong checksum applied to
the 0xU command)
See also Chapter 10, Troubleshooting, on page 117 . In case of constant
error, please contact Vaisala Service Center, see Vaisala Service
Centers on page 115 .
Table 10 Error Messaging/Text Messages Table
Text message identifier (in
NMEA 0183 v3.0 protocol only) Text Message Interpretation and action
01 Unable to measure error The requested parameters are
not activated in the message,
see
Chapter 8, Sensor and Data
Message Settings, on page 93 ,
and check the parameter
selection fields.
02 Sync/address error The device address in the
beginning of the command is
invalid. Ask the device address
with the ?! (SDI-12) or ?<cr><lf>
(ASCII and NMEA) command
and retype the command with
the correct address.
03 Unknown cmd error The command is not supported,
use the correct command format,
see
Chapter 7, Getting the Data
Messages, on page 53 .
04 Profile reset Checksum error in configuration
settings during power-up.
Factory settings used instead.
05 Factory reset Checksum error in calibration
settings during power-up.
Factory settings used instead.
06 Version reset New software version in use.
07 Start-up Software reset. Program starts
from the beginning.
08 Use chksum xxx Given checksum not correct for
the command. Use the proposed
checksum.
09 Measurement reset The ongoing measurement of all
the sensors interrupted and
started from the beginning.
10 Rain reset The precipitation sensor counter
reset.
11 Inty reset Precipitation sensor intensity
counter reset.