Wiring using the 8-pin m12 connector (optional), External wiring – Vaisala WXT510 User Manual
Page 41
Chapter 5 _______________________________________________ Wiring and Power Management
VAISALA _______________________________________________________________________ 39
Wiring Using the 8-pin M12 Connector
(Optional)
External Wiring
If WXT510 is provided with the optional 8-pin M12 connector, the
connector is located on the bottom of the transmitter, see
Figure 4 on
page 18
. The pins of the 8-pin M12 connector as seen from outside the
transmitter are illustrated in the following figure.
0308-032
Figure 17
8-Pin M12 Connector Pins
The pin connections for the 8-pin M12 connector and the wire colors of
the respective M12 cable (optional, 2/10 m) are listed in the table below.
The signal names Data in (RxD) and Data out (TxD) in the table
describe the direction of data flow as seen from WXT510.
Table 2
Pin-outs for WXT510 Serial Interfaces and Power
Supplies
/------------------ Default wiring ------------------\
RS-422 wiring
Wire Color
M12 Pin#
RS-232
SDI-12
RS-485
RS-422
Blue
7
Data out (TxD) Data in/out (Tx) Data-
Data in (RX-)
Gray
5
-
-
Data+
Data in (RX+)
White
1
Data in (RxD)
Data in/out (Rx) -
Data out (TX-)
Green
3
GND for data
GND for data
-
Data out (TX+)
Pink
6
GND for Vh+
GND for Vh+
GND for Vh+
GND for Vh+
Yellow
4
Vh+ (heating)
Vh+ (heating)
Vh+ (heating)
Vh+ (heating)
Red/Clear
1
1. Red in the internal wiring, clear in the cable (a non-insulated drain wire)
8
GND for Vin+
GND for Vin+
GND for Vin+
GND for Vin+
Brown
2
Vin+
(operating)
Vin+
(operating)
Vin+
(operating)
Vin+
(operating)