Vaisala WXT510 - Manual (Page 33)

Chapter 4 _______________________________________________________________ Installation
VAISALA _______________________________________________________________________ 31
Mounting To Horizontal Cross Arm
1. Remove the screw cover.
2. Align the horizontal cross arm in south-north-direction, see
Aligning WXT510 on page 32 .In case the cross arm cannot be
aligned, make the wind direction correction as instructed in section
Wind Direction Correction on page 34 .
3. Mount the transmitter into the cross arm by using the fixing screw
(M6 DIN933) and a nut, see
Figure 9 on page 30 and Figure 10 on
page 31 .
0505-199 Figure 10 Mounting WXT510 to Cross Arm (L-Profile)
The following numbers refer to Figure 10 on page 31 :
1 = Nut
2 = Fixing screw (M6 DIN933)