Vaisala WXT510 - Manual (Page 79)

Chapter 7 __________________________________________________ Getting the Data Messages
VAISALA _______________________________________________________________________ 77
0<cr><lf> (measurement completed)
0D0!0+069+079+084+0.1+0.6+1.1+21.1+21.7+32.0+1000.3+0.02
+20+0.0+0.0<cr><lf>
0D1!0+0+0.0+1.3+0.0+0+77.1<cr><lf>
Continuous Measurement (aR)
The device can be configured so that all the parameters can be requested
instantly with the command aR instead of the two phase request
procedure of commands aM, aMC, aC, aCC + aD. In this case the
obtained parameter values are are those from the latest internal updating
(for setting of update intervals, see
Chapter 8, Sensor and Data Message
Settings, on page 93 ).
Command format: aRx!
NOTE For using Continuous measurement commands for all WXT510
parameters (wind, PTU, precipitation, and supervisor) the respective
protocol must be selected (aXU,M=R).
The M=S selection requires use of aM, aMC, aC, aCC + aD
commands, only the precipitation data can be retrieved continuously
(using aR3 command).
where
a
= Device address
R = Start continuous measurement command:
x = The desired sensor to make the measurement:
1 = Wind
2 = Temperature, humidity, pressure
3 = Precipitation
5 = Supervisor
If x is left out, the query refers to the combined data
message used for requesting data from several
sensors with just one command.
! = Command terminator