Assembling wxt510 – Vaisala WXT510 User Manual
Page 30
User’s Guide ______________________________________________________________________
28 __________________________________________________________________ M210470EN-D
Assembling WXT510
1.
Loosen the three fixing screws at the sensor bottom assembly.
2.
Turn out the top of the transmitter.
3.
Remove the vacuum bag protecting the PTU module. Connect the
new PTU module. Make sure the module goes all the way in and is
locked into its position with the small white latch (see section A in
Figure 7 on page 28
).
4.
Avoid contacting the white filter cap with your hands while
inserting the PTU module.
5.
Replace the top and tighten the three fixing screws that fasten the
top and the bottom. When turning the top back in, make sure that
the flat cable does not get stuck or squeezed between the top and
the funnel for the flat cable.
0602-013
Figure 7
Assembling WXT510