MagTek MagneSafe V5 - Manual (Page 34)

MagneSafe V5
26
Property ID
P-
Value
Property Description HID
mode
KB
mode
Other
- 0x2F 0x2F P47 ES Track 3 End sentinel char for track 3
- 0x30 0x30 Send Encryption Counter
Enables/disables sending of Encryption
Counter
0x31 0x31 0x31 Mask Other Cards
Enables/disables masking of cards that
don’t meet the ISO Financial or the
AAMVA formats.
0x32 0x32 0x32
MSR Direction (Insert
Reader only) Defines the direction for which data will
be captured and transmitted
0x33 0x33 0x33
Card Inserted (Insert
Reader only) Indicates if a card if fully inserted into
the reader
0x34 0x34 0x34
Send clear AAMVA card
data flag Enables/disables sending of clear
AAMVA card data
0x38 - HID SureSwipe Flag
Enables/disables SureSwipe Emulation
for Security Level 2
0x3A 0x3A
Software ID 2 (wireless
reader only) The wireless reader’s software identifier
(not the dongle’s)
0x53 Inter-Key Delay Adjust delay between key reports
The Property Value is a multiple-byte field that contains the value of the property. The number
of bytes in this field depends on the type of property and the length of the property. The
following table lists all of the property types and describes them.
Property Type Description
Byte
This is a one-byte value. The valid values depend on the property.
String
This is a multiple byte ASCII string. Its length can be zero to a
maximum length that depends on the property. The value and
length of the string does not include a terminating NUL character.
Property Default Values
Each property specifies a default value. This is the firmware default value and may be changed
during the manufacturing or order fulfillment process to support the needs of specific clients.
Software ID Property
Property ID: 0x00
Property Type: String
Length: Fixed at 11 bytes
Get Property: Yes
Set Property: No
Description: This is an 11 byte read only property that identifies the software part number
and version for the reader. The first 8 bytes represent the part number and the
last 3 bytes represent the version. For example, this string might be
“21042812D01”.
For the wireless reader, two software IDs are available, one in the dongle and
one in the wireless reader. This property returns the software ID from the
dongle. To get the software ID from the wireless reader use the
“SOFTWARE ID 2” property. When the wireless reader is directly connected