MagTek MagneSafe V5 - Manual (Page 65)

Section 2. Communications
57
This property controls whether, when the reader is configured with Interface
Type HID and at Security Level 2, the reader functions as described in this
manual or as described in 99875191 (USB HID SURESWIPE & USB HID
SWIPE READER TECHNICAL REFERENCE MANUAL).
When this property is set to 0x00, the reader functions as described in this
document.
When this property is set to 0x01, the reader functions as described in
99875191 (USB HID SURESWIPE & USB HID SWIPE READER
TECHNICAL REFERENCE MANUAL). It returns card swipes as defined in
that document and enumerates with the same VID/PID as defined in the
SureSwipe document.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
Example Set HID SureSwipe Flag property Request (Hex):
Cmd Num Data Len Prp ID Data
01 02 38 01
Example Set HID SureSwipe Flag property Response (Hex):
Result Code Data Len Data
00 00
Example Get HID SureSwipe Flag property Request (Hex):
Cmd Num Data Len Prp ID
00 01 38
Example Get HID SureSwipe Flag property Response (Hex):
Result Code Data Len Data
00 01 01
Software ID 2 Property (Wireless USB Reader Only)
Property ID: 0x3A
Property Type: String
Length: Fixed at 11 bytes
Get Property: Yes
Set Property: No
Description: This is an 11 byte read only property that identifies the software part number
and version for the reader. The first 8 bytes represent the part number and the
last 3 bytes represent the version. For example, this string might be
“21042812D01”.
For the wireless reader, two software IDs are available, one in the dongle and
one in the wireless reader. This property returns the software ID from the