Es track 2 property (kb, bullet, uart, rs-232), Es track 3 property (kb, bullet, uart, rs-232) – MagTek MagneSafe V5 User Manual
Page 61
Section 2. Communications
53
ES Track 2 Property (KB, BulleT, UART, RS-232)
Property ID:
0x2E
Property Type:
Byte
Length:
1 byte
Get Property:
Yes
Set Property:
Yes
Default Value:
0xFF (use ES property)
Description:
This character is sent as the end sentinel for track 2 with any format. If the
value is 0 no character is sent. If the value is in the range 1 – 127 then the
equivalent ASCII character will be sent. If the value is 0xFF then the value of
the ES property will be used instead of this property.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
ES Track 3 Property (KB, BulleT, UART, RS-232)
Property ID:
0x2F
Property Type:
Byte
Length:
1 byte
Get Property:
Yes
Set Property:
Yes
Default Value:
0xFF (use ES property)
Description:
This character is sent as the end sentinel for track 3 with any format. If the
value is 0 no character is sent. If the value is in the range 1 – 127 then the
equivalent ASCII character will be sent. If the value is 0xFF then the value of
the ES property will be used instead of this property.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
Send Encryption Counter Property (KB, BulleT, UART, RS-232)
Property ID:
0x30
Property Type:
Byte
Length:
1 byte
Get Property:
Yes
Set Property:
Yes
Default Value:
0x00 (don’t send Encryption Counter)
Description:
This property is used to designate whether or not the Encryption Counter is
send as part of a keyboard message. If the property is set to 0x00, neither the
Encryption Counter nor the field separator will be sent. If the property is set
to 0x01, the Encryption Counter is sent as the field immediately following the
DUKPT Serial Number in a swipe message.