MagTek MagneSafe V5 - Manual (Page 64)

MagneSafe V5
56
Send Clear AAMVA Card Data Property
Property ID: 0x34
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0x00
Description: This property is used to control how to send out AAMVA card data when the
security level is above 2.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
0 – send out masked AAMVA card data
1 – send out clear AAMVA card data
Example Set Send Clear AAMVA Card Data property Request (Hex):
Cmd Num Data Len Prp ID Data
01 06 34 01 xx xx xx xx *
* where “xx xx xx xx” is the MAC.
Example Set Send Clear AAMVA Card Data property Response (Hex):
Result Code Data Len Data
00 00
Example Get Send Clear AAMVA Card Data property Request (Hex):
Cmd Num Data Len Prp ID
00 01 34
Example Get Send Clear AAMVA Card Data property Response (Hex):
Result Code Data Len Data
00 01 01
HID SureSwipe Flag Property (HID)
Property ID: 0x38
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0x00
Description: This property is only effective in USB HID mode. If you wish to send
SureSwipe data in Keyboard mode, see the KEYBOARD SURESWIPE
FLAG PROPERTY.