APC RAID Subsystem SCSI-SATA II - Manual (Page 10)

- 10 -
Chapter 2 Getting started
2.1 Before starting
Before starting, prepare the following items.
¨
Check the “Certification list” in Appendix A to confirm the hardware
setting is fully supported.
¨
Read the latest release notes before upgrading. Release notes
accompany with release firmware.
¨
A server with a NIC or iSCSI HBA.
¨
CAT 5e, or CAT 6 network cables for management port and iSCSI
data ports. Recommend CAT 6 cables for best performance.
¨
Prepare storage system configuration plan.
¨
Management and iSCSI data ports network information. When using
static IP, please prepare static IP addresses, subnet mask, and
default gateway.
¨
Gigabit LAN switches. (Recommended) or Gigabit LAN switches with
VLAN/LACP/Trunking functions. (Optional)
¨
CHAP security information, including CHAP usernames and secrets.
(Optional)
¨
Setup the hardware connection before power up servers and IS16GL.
Connect console cable, management port cable, and iSCSI data port
cables first.
2.2 Unpacking the Subsystem
Before we continue, you need to unpack the subsystem and verify that the
contents of the shipping carton are all there and in good condition. Before
removing the subsystem from the shipping carton, you should visually inspect the
physical condition of the shipping carton. Exterior damage to the shipping carton
may indicate that the contents of the carton are damaged. If any damage is found,
do not remove the components; contact the dealer where you purchased the
subsystem for further instructions.
The package contains the following items:
• iSCSI RAID subsystem unit
• Two power cords
• Three Ethernet LAN cables
• One external null modem cable
• Installation Reference Guide
• Spare screws, etc.
If any of these items are missing or damaged, please contact your dealer or
sales representative for assistance.