APC RAID Subsystem SCSI-SATA II - Manual (Page 15)

- 15 -
2.4 Connecting iSCSI subsystem to Your Network
To connect the iSCSI unit to the network, insert the cable that came with the unit
into the network connection (LAN1) on the back of iSCSI unit. Insert the other
end into a Gigabit BASE-T Ethernet connection on your network hub or switch.
2.5 Powering-on the Subsystem
You should press the ON/OFF Power Supply Switch on the Switch. It will turn the
iSCSI unit on and the Self-Test will be started automatically.
1. Plug in all the power cords or power connectors located at the rear of the
subsystem.
2. You should press the ON/OFF Power supply switch to turn on the power.
3. The “Power” LED on the front panel will turn green.