APC RAID Subsystem SCSI-SATA II - Manual (Page 35)

- 35 -
(Figure 3.5.2.1: Each of iSCSI data ports is set to static IP. MTU is 1500.)
User can change IP address by clicking the blue square button “
” in the
“DHCP” column. There are 2 selections, DHCP (Get IP address from DHCP
server) or static IP.
Figure 3.5.2.2
Default gateway can be changed by clicking the blue square button “
” in
the “Gateway” column. There is only one default gateway. The row of No. 1
would be the default gateway.
MTU (Maximum Transmission Unit) size can be changed by clicking the blue
square button “
” in the “MTU” column.
Figure 3.5.2.3
The range of MTU size is between 1500 and 9000. Default MTU size is 1500. If it
is changed, the setting of MTU size on switching hub and LAN card should be set
to the same size. Otherwise, the LAN cannot work properly.
Link aggregation setting can be changed by clicking the blue square button
“
” in the “Aggregation” column.
Figure 3.5.2.4