APC RAID Subsystem SCSI-SATA II - Manual (Page 86)

- 86 -
Warning Voltage warning Warning: System voltage is a little bit
higher/lower.
Info PSU restore Info: Power <number> is restored to work.
Error PSU Fail Error: Power <number> is out of work.
Info Fan restore Info: Fan <number> is restore to work.
Error Fan Fail Error: Fan <number> is out of work.
Error Fan non-exist Error: System cooling fan is not installed.
Error AC Loss Error: AC loss for the system is detected.
Info UPS Detection OK Info: UPS detection succeed
Warning UPS Detection Fail Warning: UPS detection failed
Error AC Loss Error: AC loss for the system is detected
Error UPS power low Error: UPS Power Low!!! The system will do the
auto shutdown immediately.
Info Mgmt Lan Port
Active Info: Management LAN Port is active.
Warning Mgmt Lan Port
Failed Warning: Fail to manage the system via the
LAN Port.
Info RTC Device OK Info: RTC device is active.
Warning RTC Access Failed Warning: Fail to access RTC device
Info Reset Password Info: Reset Admin Password to default.
Info Reset IP Info: Reset network settings set to default.
· System config events
Level Type Description
Info Sys Config.
Defaults Restored Info: Default system configurations restored.
Info Sys NVRAM OK Info: The system NVRAM is active.
Error Sys NVRAM IO
Failed Error: Can’t access the system NVRAM.
Warning Sys NVRAM is full Warning: The system NVRAM is full.
· System maintenance events
Level Type Description
Info Firmware
Upgraded Info: System firmware has been upgraded
Error Firmware
Upgraded Failed Error: System firmware upgrade failed.
Info System reboot Info: System has been rebooted
Info System shutdown Info: System has been shutdown.
Info System Init OK Info: System has been initialized OK.
Error System Init Failed Error: System cannot be initialized in the last
boot up.
· LVM events
Level Type Description
Info VG Created OK Info: VG <name> has been created.