APC RAID Subsystem SCSI-SATA II - Manual (Page 65)

- 65 -
was also imported, the user’s current data will be cleared. Below is table of
available configuration in import & export function.
System name Controller system name
IP address Web UI IP address with (1) DHCP enabled, (2) IP, (3)
Subnet mask, (4) Gateway, (5) DNS
iSCSI iSCSI data port address with (1) Aggregation, (2) iSNS,
(3) CHAP, (4) LAN 1 IP, Aggregation, IP, Subnet mask,
Gateway, MTU
Login config Admin account login config with (1) Auto logout setting,
(2) Admin login lock
Password Admin password value with (1) Current password, (2)
Old password
Date Time Zone setting
Mail Event log mail setting with (1) Mail_from address, (2)
SMTP server, (3) Authentication, (4) Mail account ID,
(5) Mail password, (6) Mail_To_1 address, (7)
Mail_To_2 address, (8) Mailt_To_3 address, (9) Event
log filter setting
SNMP SNMP setting with (1) SNMP trap address 1, (2) SNMP
trap address 2, (3) SNMP trap address 3, (4)
Community setting, (5) Event log filter function
Event log Event log filter setting with (1) Web UI and console UI
setting, (2) LCM setting, (3) Web UI pop up event
setting
SES config SES management setting
vol_temp Auto shutdown setting
UPS UPS setting with (1) UPS type, (2) Shutdown Battery
Level, (3) Shutdown Delay, (4) Shutdown UPS
Physical disk Not available in import function.
Current controller hard disk status with (1) size, (2)
block size, (3) VG, (4) hard status