elektraLite P100 Manual Part Two - Manual (Page 18)

90
This deletes specific presets.
Delete Submaster p.f …
Delete Submaster Page n …
These delete specific submaster fader assignments, or specific pages.
Dimmer
This switches to the DIMMER FEATURES display.
Dimmer p.f …
This copies specific dimmer fader assignments into the cue editor as though they were cues. If Solo is
on, this first clears the cue editor; otherwise, the new settings are combined with the existing ones.
Where there are conflicts, higher values override, because dimmer values are always HTP.
Dimmer n … @ n
Dimmer n … @ Full
These set the brightness of specific dimmers if they are currently part of the cue editor. They don't add
any dimmers to the cue editor.
Dimmer Group
This switches to the DIMMER GROUPS display.
Dimmer Group n
This selects a specific group of dimmers, and switches to the DIMMER GROUPS display.
Dimmer Group n … @ n
Dimmer Group n … @ Full
These set the brightness of dimmers in specific dimmer groups if they are currently part of the cue
editor. They don't add any dimmers to the cue editor.
Dimmer Page n
Dimmer Submaster Page n
These select a specific dimmer page. Both are equivalent.
Dimmer Submaster
Dimmer Submaster p.f
These switch to the DIMMER SUBMASTERS display. The first one selects the first fader in the
current page, and the second selects a specific fader.
Dimmer Submaster p.f … @ n
Dimmer Submaster p.f … @ Full
These set specific dimmer submasters to specific values, as though the faders had moved. Note that
they cannot change the "position" of virtual fader zero, which is always at maximum. They can,
however, access dimmer submasters in all 99 pages, not just the current page, even if dimmer Latch
mode is off.
Edit
This switches to the CUE EDITOR display, and forces any running crossfade to complete.
Edit Back
This loads the next lower-numbered cue into the cue editor, without doing a timed crossfade. There is