elektraLite P100 Manual Part Two - Manual (Page 71)

143
Procedure for resetting the default CMOS setting.
The following procedure is for CP-100 consoles that have had their CMOS default settings altered.
This error can occur as a result of static shock or heavy electrical fluctuation in various environments.
The solution is possible to do without a monitor connected. However it is a darn sight easier if you
can connect one up. If you want to connect up a monitor you are going to have to have fitted a video
card. Video cards are available from your Elektralite distributor or from Elektralite direct.
SYMPTOM: The Disk Drive appears not to work.
SOLUTION: Perform the following steps.
1- Connect a standard Windows 95 keyboard to the keyboard jack on the rear panel of the console.
2- Power up the console.
3- Hold the “Del.” button on the keyboard for 15 seconds.
4- Press “Enter”
5- Press the down arrow key 8 times.
6- Press the “Page Up” key 2 times.
7- Press “Esc.”
8- Press the down arrow key 3 times.
9- Press “Enter”
10- Press “y”
11- Press “Enter”
12- Press “F10”
13- Press “y”
14- Press “Enter”
15- Wait for complete reboot of the software (approximately 30 seconds)
This restores the default settings of the operating system and reconfigures it to recognize the diskette
drive.