elektraLite P100 Manual Part Two - Manual (Page 24)

96
Submaster
Submaster p.f
These switch to the SUBMASTERS display. The first one selects the first fader in the current page,
and the second selects a specific fader.
Submaster p.f … @ n
Submaster p.f … @ Full
These put specific submasters into manual mode at a specific level (in 0..100) or at maximum level.
Note that they cannot change the "position" of virtual fader zero, which is always at maximum. They
can, however, access submasters in all 99 pages, not just the current page, even if submaster Latch
mode is off.
Submaster p.f … Go
This starts specific submasters. If they contain cues with nonzero fade-in times, the cues fade in. Note
that this cannot be used on virtual fader zero. It can, however, access submasters in all 99 pages, not
just the current page, even if submaster Latch mode is off.
Submaster p.f … Stop
This stop specific submasters, if running. If they contain cues with nonzero fade-out times, the cues
fade out. Note that this cannot be used on virtual fader zero. It can,
however, access submasters in all 99 pages, not just the current page, even if submaster
Latch mode is off.
Submaster Page n
This selects a specific submaster page.
Submaster Stop
This stops all running submasters immediately (except for submaster zero).