elektraLite P100 Manual Part Two - Manual (Page 61)

133
10.To record the third entry Press CHASE "n" STOP ENTER The entry numbering will look like the
(a chase stopped) following:-
1>clear cue
2>cue 20 (for example)
3>stop chases (reset)
4>chase 100 (for example)
5>stop chase 100
11. Setting up the times for First use the ^ key to go down the Tip: It is easier if you do all the
the first entry entries to the first entry entries first and then enter in the
times.
The first entry is the clear cue. Its
time is usually left alone at 0:00.0
The times on the screen represent
Absolute Time and Relative Time.
Ab T is the 0:00:00.0 to the left hand
side of the screen. Rel T is to the
right.
12.Setting up the time for Use the v key to go up to the 2nd Enter your time on the Rel T scale.
the second entry entry. 00(mins):00.0(secs).
For example 00:10.0 = 10 seconds.
13.Setting up the time for Use the v key to go up to the 4th For example 00:05.5 = 5.5 seconds
the fourth entry entry. This will make the Ab T display
0:00:10.0 (note: the third entry is for
the chase reset so it has a time 0).
14.Examining the time for Use the v key to go up to the 5th The fifth entry is stop chase, again
the fifth entry entry the time will be 0. However observe
the Ab T it is now at 0:00:15.5
15.Storing the Macro Press RECORD Press STORE MACRO "n" The Macro must be stored to a macro
ENTER number.
STORING TO A SUBMASTER
It needs to be decided as to whether the board is going to be operated with or without the Submasters latched on or not. If the submasters are not latched
then, for example, if you have submaster 2 up on page 6 and you move to page 7 then the output from submaster 2 remains on and the led in the flash button