elektraLite P100 Manual Part Two - Manual (Page 60)

132
FUNCTION FIRST BUTTON SEQUENCE SECOND BUTTON SEQUENCE NOTES
6.Solo or not to solo Press the SOLO button If the Solo button Led is on the Solo
function is on. This will make each
entry of the macro
a single cue or chase.You can make an
entry hold multiple cues and/or chases
by having the solo button off. However
great care must be taken to avoid
conflict between cues and/or chases.
If you enter 2 cues and they have the
same fixtures in them then there will
be a conflict as to which cue the
fixture should execute. In fact the
conflict is resolved by a compromise
The cues combined which is logical.
However the resultant output on
stage maybe not what you want!!
7. To start Recording the Macro Press MACRO RECORD The record button is now flashing.
8. To record the first entry
Press CUE "n" ENTER After you have made your entry, the
(a cue) entry number automatically jumps to
3>. This is deliberate. Entry 2 is the
cue you just entered and entry 1 is an
automatic “clear" function. This
clears out the buffer ready for you to
program the first entry. If the solo
button was off you would not get this
“clear cue" entry, because it would
be the case that you want to "pile-on"
cues and/or chases.
9. To record the second Entry Press CHASE "n" GO ENTER
(a chase in motion)
STORING A MACRO
(continued)
FUNCTION FIRST BUTTON SEQUENCE SECOND BUTTON SEQUENCE NOTES