AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual - Manual (Page 212)

206
© 2014 AEM Performance Electronics
Infinity User Manual
Nitrous RPM Min:
Units: RPM
If all other conditions are met, Nitrous will turn on when EngineSpeed [RPM] reaches this value.
Nitrous RPM Max:
Units: RPM
Maximum EngineSpeed [RPM] before Nitrous turns off.
Nitrous RPM Reinstate:
Units: RPM
EngineSpeed [RPM] to turn Nitrous back on.
Nitrous Triggers: Arm Switch, Gear, VSS, Throttle, Boost:
Nitrous Minimum Gear:
Units: Gear
Lowest gear for enabling Nitrous
Nitrous Minimum Vehicle Speed:
Units: Gear
Lowest vehicle speed for enabling Nitrous
Nitrous TPS On Above:
Units: Throttle %
Minimum value for TPS [%] to enable Nitrous
Nitrous TPS Off Below:
Units: Throttle %
Maximum value for TPS [%] before Nitrous is turned off
Nitrous MAP Max:
Units: Pressure
Maximum value for MAP before Nitrous is turned off.
Nitrous MAP Reinstate:
Units: Pressure
MAP must drop below this value before Nitrous is turned back on.
Nitrous Output and Trims:
Nitrous Lambda Target Trim:
Value to adjust LambdaTarget by leaving alone or or leaning it out during Nitrous. Min value =
-0.2, Max value = 0.