AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual - Manual (Page 361)

Wiring, Pinouts and Schematics 355
© 2014 AEM Performance Electronics
Infinity Pin Hrdwr Ref. Hardware Specification Notes
C1-37 Analog_In_9 12 bit A/D, 100K pullup to 5V 0-5V analog signal. Use +5V Out pins as power
supply and Sensor Ground pins as the low
reference. Do not connect signals referenced to
+12V as this can permanently damage the ECU. See
the Setup Wizard Fuel Pressure page for setup and
calibration.
C1-38 Analog_In_10 12 bit A/D, 100K pullup to 5V 0-5V analog signal. Use +5V Out pins as power
supply and Sensor Ground pins as the low
reference. Do not connect signals referenced to
+12V as this can permanently damage the ECU. See
the Setup Wizard Barometric Pressure page for
setup and calibration.
C1-39 Analog_In_11 12 bit A/D, 100K pullup to 5V 0-5V analog signal. Use +5V Out pins as power
supply and Sensor Ground pins as the low
reference. Do not connect signals referenced to
+12V as this can permanently damage the ECU.
Normally used as Shift Switch input.
C1-40 Analog_In_12 12 bit A/D, 100K pullup to 5V 0-5V analog signal. Use +5V Out pins as power
supply and Sensor Ground pins as the low
reference. Do not connect signals referenced to
+12V as this can permanently damage the ECU.
Normally used as Mode Switch input.
C1-41 +5V_Out_1 Regulated, fused +5V supply for
sensor power Analog sensor power
C1-42 +5V_Out_1 Regulated, fused +5V supply for
sensor power Analog sensor power
C1-43 HighsideSwitch_1_Out 0.7A max, High Side Solid State
Relay See Setup Wizard page 'HighSide Assigment Tables'
for configuration options.
C1-44 HighsideSwitch_0_Out 0.7A max, High Side Solid State
Relay See Setup Wizard page 'HighSide Assigment Tables'
for configuration options.
C1-45 Crankshaft Position
Sensor VR+_In Differential Variable Reluctance
Zero Cross Detection See Setup Wizard page Cam/Crank for options.
C1-46 Crankshaft Position
Sensor VR-_In See Setup Wizard page Cam/Crank for options.
C1-47 Camshaft Position
Sensor 1 VR-_In Differential Variable Reluctance
Zero Cross Detection See Setup Wizard page Cam/Crank for options.
C1-48 Camshaft Position
Sensor 1 VR+_In See Setup Wizard page Cam/Crank for options.