3 gateway rack configuration – 2N StarGate/BlueTower v5.3 User Manual
Page 47
47
1.
2.
2.3 Gateway Rack Configuration
The
gateways use different hardware rack types. For
2N StarGate
®
/ BlueTower
detailed information on the differences refer to the
subsection All the
systems can be distributed with a VoIP, ISDN or VoIP+ISDN interface. The main back
bus located in the gateway hardware rack is pre–configured to a defined type of
interface (VoIP, PRI and VoIP+ISDN). There are six jumpers on the main bus between
the 3 and 4 connector (from the right).The jumper lay-out shown below applies to
rd
th
all the connection types
(VoIP, ISDN, VoIP+ISDN).
Keep the jumpers connected as shown below to make your
system work properly.
There are three setting options:
ISDN: The gateway is configured to work with the ISDN PRI card only as shown
in the figure below:
VoIP: The gateway is configured to work with the VoIP card only as shown in the