2N StarGate/BlueTower v5.3 User Manual
Page 86
86
called minutes limit has been exhausted.
enable/disable SIM switching when the
Daily minutes limit exceeded –
maximum daily minutes limit has been exhausted.
Send CLIP from VoIP/ISDN to GSM/UMTS
Transfer CLIP to GSM/UMTS – enable/disable the function.
Separating char – define the CDN/CLIP separating character.
Modify (‘–’ remove one digit) – change the CLIP. The ‘–’ character is used for
deleting one character from the left.
Caution
The Send CLIP from VoIP to GSM service must be supported by
the GSM/UMTS provider’s network. Otherwise, the call may be
rejected by GSM/UMTS!
Basic Settings
Roaming enabled for network code – set the international network identifier
for roaming purposes consisting of the following two codes:
MCC – Mobile Country Code – country code (Czech Republic – 230);
MNC – Mobile Network Code – GSM code (T–Mobile – 01, 0202, Vodafone
– 03).
Hence, the international identification code for T–Mobile CZ is 23001. Leave this field
empty to disable roaming.
Input
Note
<empty> Roaming is restricted
2300
Roaming is restricted (minimum is five digits)
23002
Roaming is permitted for network with MCC+MNC code 23002
230XX
Roaming is permitted for network with MCC+MNC codes 23000 – 23099
XX001
Roaming is permitted for network with MCC+MNC codes 00001 – 99001
XXXXX
Roaming is permitted for any network
Note
Before activating the roaming support, please check the SIM
card for correct setting of the GSM / UMTS priority network list.
Caution
Calls via roaming networks may cause additional call costs!
CLIR – enable/disable presentation of the SIM CLIP on the called party’s
telephone. CLIR is recommended for the SIM card inserted in the GSM module to
avoid CallBack problems.