Pri1 alerts, Isdn parameters – monitoring – 2N StarGate/BlueTower v5.3 User Manual
Page 79
79
– with this parameter activated, the
Receive dial number from Subaddress
gateway uses the digits in the Subaddress field instead of the Called party
number for outgoing dialling.
– a specific feature designed for the
Hungarian dial tone after 2 digits
Hungarian national dialling plan. The gateway activates a specific dialtone for
second dialling after receiving two digits.
– when the ISDN PRI is in the TE mode, the
Don't send ConnectAck on TE
gateway will not send the CONNECT_ACK message.
Use CLIR if requested from ISDN (SETUP)
– enable automatic CLIR
resending to GSM/UMTS if required so by the ISDN.
Tone Signalling for Calls from ISDN
Dial tone to PRI1 with empty SETUP – set the dial tone type to be generated
by the PRI gateway.
Ring tone – set the ring tone type to be generated by the PRI gateway.
Generate busy tone to PRI1 – set the busy tone type to be generated by the
PRI gateway into the PRI 1 interface.
Generate busy tone to PRI2 – set the busy tone type to be generated by the
PRI gateway into the PRI 2 interface.
set the ring tone type to be generated by the
Ring tone from PRI1 to PRI2 –
PRI1 interface into the PRI 2 interface.
Numbering Plan Settings
– use these parameters to set the Numbering plan for the called
CDN, CGN
(CDN) and calling (CGN) numbers.
Binary value
Decimal value
Description
0000
0
Unknown numbering plan
0001
1
ISDN/Telephony numbering plan
0011
3
Sata numbering plan
0100
4
Telex numbering plan
1000
8
National standard numbering plan
1001
9
Private numbering plan
1111
15
Reserved for Extension
ISDN Parameters – Monitoring
Caution
This service is file-licensed. Refer to Management–>Licence
for the current GSM gateway licence details.
key
PRI1 alerts
Send SMS at state changes – enable/disable alert sending upon PRI1 state
change.