2N StarGate/BlueTower v5.3 User Manual
Page 89
89
General settings
– set how the gateway shall process incoming calls from the GSM network.
Mode
Reject incoming calls – all incoming calls from the GSM network are
rejected automatically.
Ignore incoming calls – all incoming calls from the GSM network are
ignored. The calling party hears the check ring tone.
Accept incoming calls+ voice message – incoming GSM calls are
accepted by the gateway and, if programmed so, DTMF with a voice
message is activated for them.
Accept incoming calls + dialtone – incoming GSM calls are accepted by
the gateway and, if programmed so, DTMF with a simulated second
dialtone is activated for them.
CallBack after ring / Reject – CallBack will be made if the CLIP is
included in the CallBack table. The other incoming calls will be rejected.
CallBack after ring / Ignore – CallBack will be made if the CLIP is
included in the CallBack table. The other incoming calls will be ignored.
Report to PC + voice message – the GSM gateway sends information on
the incoming call to a PC equipped with call routing application. If
programmed so, DTMF with a voice message is activated for the incoming
call.
Report to PC + dialtone – the GSM gateway sends information on the
incoming call to a PC equipped with call routing application. If programmed
so, DTMF with a simulated second dialtone is activated for the incoming
call.
Minimum digits in DTMF – set the minimum count of digits to be requested by
the gateway for DTMF.
Maximum digits in DTMF – set the maximum count of digits to be accepted by
the gateway for DTMF.
Timeout for entering DTMF digits [s] – set the timeout for which the GSM
gateway shall wait for the first/next DTMF digit. If you select ‘0’, the incoming
call will be automatically connected to the numbers included in the List of called
numbers.
Day of deleting GSM group statistics – set a day in a month on which the
incoming call statistics shall be deleted.
Prefix before DISA – set a numerical prefix to precede DTMF.
CLIP – use this parameter to modify the incoming CLIP from GSM/UMTS. For
international codes, ‘+’ will be removed automatically. Use ‘–’ to remove a digit.
Examples (CLIP in GSM: +420600123456):
Parameter
value
CLIP to
VoIP/PRI 1
Note
Null
420261301500
No change in CLIP
+
+420261301500
Add + before CLIP beginning
00
00420261301500
Add 00 before CLIP beginning
––
0261301500
Remove two first digits from CLIP beginning
–––99
99261301500
Remove first three digits and add 99 before CLIP
beginning