Default parameters, 5 default parameters – INFICON UL1000 Helium leak detector User Manual
Page 33
Installation
33
iina
70
e 0
2
.f
m
te
chn
ica
l ha
nd
boo
k
(1
40
8)
2.5
Default parameters
The following parameters are set like shown when in the menu of the UL1000 and
UL1000 Fab under Settings
Parameters load/save, „load default values“ is
chosen.
Auto-scaling:
On
Scaling
logarithmic
Display range:
4 decades
Time axis:
32 seconds
LCD invers:
OFF
Background in stand by mode:
OFF
Automatic calibration request:
OFF
Mass:
4 (helium)
Recorder Output:
leak rate
Volume:
2
Leak rate unit:
mbar l/s
Mode:
Vacuum
Trigger level 1:
1E-9 mbar l/s
Trigger level 2:
1E-8 mbar l/s
Leak rate external test leak (Vacuum):
1E-7 mbar l/s
Leak rate external test leak (Sniffer):
1E-5 mbar l/s
Vent delay:
2 seconds
Automatic purge:
OFF
Pressure unit:
mbar
Minimum volume:
0
Beep:
ON
Maximum evacuation time:
30 minutes
Audio Alarm Typ:
Trigger Alarm
Maximum inlet pressure when sniffing:
1 mbar
Minimum Inlet pressure when sniffing:
0,1 mbar
Number of decimal place at leak rate displayed:
1
Scroll display:
On
Particle protection:
Off
Direct access to calibration:
On
Contamination protection:
Off
Switch off limit for contamination protection:
1E-3 mbar l/s
Control location:
Local
Alarm delay:
30 seconds
Leak rate filter:
I•Cal
Zero:
enabled