INFICON STM-100/MF Thin Film Deposition Monitor - Manual (Page 65)

_________________________________________________________________________
Command: K
Parameter: [@,!,?]
Description: Turns the test mode on and off. A "@" will turn the test mode off, a "!" will turn it on,
and a "?" will return the current status.
_________________________________________________________________________
Command: L
Parameter: None
Description: Acknowledges valid receipt of power on status and resets internal flags. See "a"
command.
_________________________________________________________________________
Command: M
Parameter: None
Description: Returns the crystal fail status. If a "@" is returned, the crystal is good. A status of "!"
indicates that the crystal has failed.
_________________________________________________________________________
Command: N
Parameter: None
Description: Returns the status of the setpoint timer relay. If a "@" is returned, the relay is open
(time has not been reached). A status of "!" indicates that the relay is closed (time
has been reached).
_________________________________________________________________________
Command: O
Parameter: None
Description: Returns the status of the setpoint thickness relay. If a "@" is returned, the relay is
open (thickness has not been reached). A status of "!" indicates that the relay is
closed (time has been reached).
Turn the Test Mode
On/Off
Acknowledge the
Status of Non-Volitile
Memory
Get the Crystal Fail
Status
Get the Status of the
Setpoint Timer Relay
Get the Status of the
Setpoint Thickness
Relay
COMPUTER INTERFACING Page 5 - 10