Kinze 3500 Lift and Rotate Planter Rev. 7/14 - Manual (Page 21)

TM
Model 3500 M0240-01
6/11 2-9
Machine Operation
There are two down pressure springs on each contact drive wheel. Spring tension is factory preset and normally
requires no adjustment.
Basic setting for spring tension is approximately 200 lb (90.72 kg) of down force at tire contact point.
NOTE: Measurement must be taken in planting position with proper tire pressure.
CONTACT DRIVE SPRING ADJUSTMENT
Down pressure spring location
8" (20.3 cm)
Spring length measurement (Factory setting)
TOWING PLANTER
WARNING
All safety/warning lights, reflective decals, and SMV sign must be
in place and visible before transporting machine on public roads or
death, serious injury, and damage to property and equipment may
result. Check federal, state/provincial, and local regulations before
transporting equipment on public roads.
DANGER!
Contacting or coming close to power lines or other high energy
sources will cause death or serious injury. Keep away from power
lines or high energy sources at all times.
• Tow only with farm tractor rated and configured for equipment.
• Know your route and be aware of any obstructions.
• Follow all road and bridge load limit restrictions.
• Never exceed maximum transport towing speed of 20 mph (32 kph).
NOTICE
Raise planter out of ground when making sharp turns or backing
up or damage to tractor and equipment can occur.
PLANTING SPEED
Planters are designed to operate within a speed range of 2 to 8 mph (3.2 - 12.8 kph). See “Rate Charts”. Variations in
ground speed produce variations in rates. Finger pickup seed meter populations tend to be disproportionately higher at
high ground speeds.
NOTE: Seed spacing can be adversely affected at speeds above 5.5 mph (8.8 kph).