Leica Biosystems ST4040 - Manual (Page 17)

17 Leica ST4040 – Linear Stainer
3.6.2 Installing the drain hose
• Connect the drain hose.
Upon installing the drain hose make
sure there is a gradient from the drain
outlet to the waste pipe.
3.6.3 Installing the exhaust air hose
• Connect the exhaust air hose (optional!).
The instrument may be operated ei-
ther with the exhaust air hose or
with the activated carbon filter.
3.5.2 Connecting the power chord to the
• Remove the adhesive tape from the mains
inlet.
• Select the appropriate power chord (the in-
strument is delivered with several, country-
specific power chords) and connect it to the
mains inlet at the rear of the instrument.
• Do not yet plug the power chord into the wall
outlet.
• The unload sensor port remains empty; un-
less the instrument is operated with optional
unload station (see Chapter 4).
3. Installation
3.6 Installing the accessories
3.6.1 Installing the water inlet hose
• Install the inlet hose, which supplies water
to the tap water stations.
instrument