Leica Biosystems ST4040 - Manual (Page 19)

19 Leica ST4040 – Linear Stainer
3.6.7 Inserting the activated carbon filter
If the instrument is not connected to a
fume hood (via exhaust air hose), an
activated carbon filter must be used!
• To insert the activated carbon filter, open the
hinged front panel: press the two locking pins,
which are located on the top right and left on
the inside of the front panel.
• Remove the the activated carbon filter from
the package.
• Write the current date on the filter (to be re-
minded to replace the filter in time).
3.7 Plugging the power chord into
the wall outlet
• Prior to plugging the power chord into the
wall outlet, check whether the mains switch
is in OFF (‘0’) position.
• Connect the power chord to the wall outlet.
3. Installation
• Insert the activated carbon filter.
• Close the front panel. While applying light
pressure to the front panel, press the two
locking pins to lock the panel into place.