7 programming, Programming, Operation – Leica Biosystems ST4040 User Manual
Page 35
35
Leica ST4040 – Linear Stainer
6.7
Programming
Programming must be done while in stand-by mode. The instrument
can store 2 programs: (buttons ‘Prog 1’ and ‘Prog 2’).
•
Select a program (‘Prog 1’ or ‘Prog 2’).
•
Press the desired button (here ‘Prog 1’) and hold for approx. 5 seconds
- until the LED in the button starts flashing.
•
Press the ‘Immersion time’ button:
•
The LED in the button lights up.
•
Use the ‘+/-’ buttons to select the desired value.
•
Immersion time can be set from 0 seconds up to 99 minutes, 59 sec-
onds.
•
To set the time, the button can be pressed and released - going up or
down step by step - or it can be pressed and held. -
If the button is pressed and held, the display scrolls faster.
•
Press the ‘Draining time’ button:
•
The LED in the button lights up.
•
Use the ‘+/-’ buttons to select the desired value.
6.
Operation