Lenze E94AYCDN - Manual (Page 8)

1 About this documentation
1.3 Terminology used
8
Lenze · E94AYCDN communication module (DeviceNet™) · Communication Manual · DMS 5.0 EN · 02/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1.3 Terminology used
Term Meaning
Drive Lenze inverters of the "Servo Drives 9400" product series
Standard device
Code
Parameter which serves to parameterise and monitor the drive. In normal usage,
the term is usually referred to as "Index".
Subcode If a code contains several parameters, they are stored in so-called "subcodes".
This manual uses a slash "/" as a separator between code and subcode
(e.g. "C00118/3").
In normal usage, the term is also referred to as "Subindex".
CoS Change of State
CoS nodes always transmit their data if the data status changes.
Device DeviceNet slave
DeviceNet™ is a fieldbus system based on CAN (Controller Area Network).
DeviceNet™ is a trademark and patented technology, licensed by the user
organisation ODVA (Open DeviceNet Vendor Association), USA.
»Engineer« PC software from Lenze which supports you during engineering
(parameterisation, diagnostics, and configuration) throughout the entire life
cycle, i.e. from planning to maintenance of the commissioned machine.
Explicit messages Parameter data
HW Hardware
Host DeviceNet master
Scanner
Lenze setting
Setting with which the device is preconfigured ex works.
»RSLogix 5000« Programming and development software by Rockwell for hosts (PLCs, scanners)
in DeviceNet networks (e.g. Allen Bradley Logix control systems).
SW Software