4 mechanical installation, 1 drilling the holes into the mounting plate, Mechanical installation – Lenze EVF9383 User Manual
Page 77: Drilling the holes into the mounting plate, 4mechanical installation
Mechanical installation
Drilling the holes into the mounting plate
4
l
77
EDKVF9383 DE/EN/FR 4.0
4
Mechanical installation
I
Tip!
ƒ
Lenze recommends to install an air lock. The air lock serves to dissipate the
heated cooling air directly from the control cabinet.
– Order no. E93ZWL2
ƒ
A drilling jig for marking the bore holes is available as dxf−file in the
Internet in the "Download" area under www.Lenze.de.
4.1
Drilling the holes into the mounting plate
Assembly space
Minimum clearance
Left/right of other controllers
30 mm
Left/right of a non−heat−conducting wall
100 mm
Top/bottom
200 mm
Comply with the clearances given to ensure a sufficient cooling of the controller. When
using an air lock, different clearances apply (see Mounting Instructions for the air lock).
a
a1
a1
a1
a1
a3
a3
a2
a2
a2
a2
d
b
93vec079
Fig.4−1
Bore holes in the mounting plate for fixing the controller
a
a1
a2
a3
b
d
550 mm
450 mm
340 mm
225 mm
1005 mm
9 mm (24x)
1. Mark the bore holes on the mounting plate according to the figure.
2. Drill the holes into the mounting plate.