Lenze MCH Series - Manual (Page 32)

28 13435744_EDBMH01_v13
13.2 MCH DISPLAY
This section describes the possible display configurations for the MCH Series drive
when operating as a standard drive (without PID control). Refer to Section 19.0 - MCH
PID SETPOINT CONTROL for a complete description of drive operation when using
PID control.
13.2.1 MCH DISPLAY IN STOP MODE
When the drive is in the STOP mode, there are two possible displays: load and motor
voltage. The standard display indicates % LOAD as illustrated herein.
DRIVE
STATUS
SPEED
SETPOINT
KSTOP > 20.00 HZ
0 % LOAD OFF
LOAD
METER
HAND/OFF/AUTO
STATUS
SPEED
UNITS
DIRECTION
(FORWARD)
NOTE
For the SPEED UNITS display options refer to Parameter 31 -
UNITS.
Pressing the ENTER key will change the display from the % LOAD indication to the VAC
(motor voltage) indication:
DRIVE
STATUS
SPEED
SETPOINT
KSTOP > 20.00 HZ
0 VAC OFF
MOTOR
VOLTAGE
HAND/OFF/AUTO
STATUS
SPEED
UNITS
DIRECTION
(FORWARD)
Pressing ENTER again will change the display back to the % LOAD indication.
The table herein lists the possible DRIVE STATUS indications that may appear on the
drive display and provides a description of each.